All guides

Saving prompts for later with the Backlog

The Backlog is a list of prompts you want to run later. Each item becomes a normal session when you start it, with Claude, Codex or OpenCode. Nothing in the backlog runs until you start it, or until a schedule you set fires.

The backlog belongs to the project. Every window of that project, and the phone, shows the same list.

1. Save a prompt

  1. Open Backlog in the sidebar.
  2. Select + New.
  3. Write the prompt. It is sent as the session’s opening message, as written. Drop files into the box to insert their paths.
  4. Optionally set a Session name and pick a Model. Default uses your usual one.

The item saves on its own, and the header says Saved. If you leave text unsaved, SimpleEdit keeps it as a draft until you add or discard it. An item needs a name or a prompt.

On the phone, the Backlog tab lists the same items and opens an Add to backlog sheet, so you can save a prompt when you think of it.

Items under Up next are one-time items. Drag them to change the order.

2. Start an item

Select Start on the item. A new session opens with your prompt, in the project’s main worktree. The item leaves the list. If the session can’t start, the item stays and says why. If it May have started, check the sidebar before you start it again.

3. Run it on a schedule

An item can also start on a schedule, daily or weekly for example. See Running agents on a schedule.

4. When an agent adds an item

Ask any of your agents, whether Claude, Codex or OpenCode, to “add this to our backlog”. It adds the item to the project’s backlog instead of starting a session. You see a notice, “Added to backlog by ‹session›”, with Edit.

An agent can add and edit items. It cannot start them. If it adds one with a schedule, the item lands paused, as Running agents on a schedule explains.

An item without a schedule shows “Prepared by ‹session›. Read it before you start it.” Start it like any other.